YS PRO is a big data solution, collecting and sending data through a wide range of sources.
YS PRO only sends data when it has a 3G/4G signal. All data can be recorded for months and sent later if it is out of range. YS Pro collect 5 types of data:
1/ Internal YS Pro data
It includes internal alarms (geofencing, battery, tilt, temperature and G-shock alarms), 3G/4G & GPS signal strength and Wi-Fi statistics and settings. These data are collected and sent 24/7.
2/ Data from power cable and voltage detector cable(s)
YS Pro power cable can monitor the voltage of up to 3 batteries. Alarms can be configured if the voltage in any of these 3 batteries drop below a pre-set level. Each voltage detector cable can detect if the electric appliance it is wired to (typically bilge pump, water maker, generator or engine) is in use or not. Statistics about past usage is then shown on the app and can be used for maintenance purposes. These data are collected and sent 24/7.
3/ Data from optional wireless sensors
Any triggers from a sensor would result in an alarm being sent by YS Pro to the app (and the Partner Platform if applicable). YS Pro also collects the Zigbee signal strength and the battery level of each sensor multiple times per day. These data are collected and sent 24/7.
4/ Data from NMEA 2000 or other CAN bus
If connected to a CAN bus (NMEA 2000, CANOPEN, J1939), YS Pro collects any data from the bus when the bus is turned on. It includes:
– Engine data
– Battery data
– Temperature and humidity data
– Fluid levels data
– GPS coordinates, heading, ground & water speeds
– Wind force & direction, water depth
If the bus is turned off and YS Pro relay is connected to the NMEA network, users can click on the “update” button on the app, which will automatically turn on the CAN bus for a few minutes, collect the data and turn the CAN bus off.
5/ Video footage from Sentinel Cam 2
If a sim card is inserted in YS Pro, YS Pro can act as a Wi-Fi router and send a short video to the app if Sentinel Cam 2 detects an intrusion.